Description

I used the Arduino board, other fun items in the lab kit, and pre-exisiting code to make an LED blink. (It blinked blue - how exciting!)

Code

/* Blinking LED
* ------------
*
* turns on and off a light emitting diode(LED) connected to a digital
* pin, in intervals of 2 seconds. Ideally we use pin 13 on the Arduino
* board because it has a resistor attached to it, needing only an LED
*
* Created 1 June 2005
* copyleft 2005 DojoDave <http://www.0j0.org>
* http://arduino.berlios.de
*
* based on an orginal by H. Barragan for the Wiring i/o board
*/

int ledPin = 13; // LED connected to digital pin 13

void setup()
{
pinMode(ledPin, OUTPUT); // sets the digital pin as output
}

void loop()
{
digitalWrite(ledPin, HIGH); // sets the LED on
delay(1000); // waits for a second
digitalWrite(ledPin, LOW); // sets the LED off
delay(1000); // waits for a second
}

Photo