Lab 1--

Use the Arduino to control a light emitting diode and make it blink.

Components Used--

Light Emitting Diode (LED)
Resistor

Code--

* Lab 1 --Theory and Practice of Tangible User Interfaces

*Turns on an LED on for one second,
* then off for one second, and so on... We use pin 13 because,
* depending on your Arduino board, it has either a built-in LED
* or a built-in resistor so that you need only an LED.
*
* http://www.arduino.cc/en/Tutorial/Blink
*/

int ledPin = 13; // LED connected to digital pin 13

void setup() // run once, when the sketch starts
{
pinMode(ledPin, OUTPUT); // sets the digital pin as output
}

void loop() // run over and over again
{
digitalWrite(ledPin, HIGH); // sets the LED on
delay(1000); // waits for a second
digitalWrite(ledPin, LOW); // sets the LED off
delay(1000); // waits for a second
}

Aithne Sheng-Ying Pao's Lab1, large