November 24, 2007
Reading for November 27th, are now posted. Enjoy!

October 2, 2007
To upload your thoughtless acts, create a new assignment page like any other lab. You'll see "Thoughtless Acts" listed as one of the assignment options.

May 24, 2008
This site has been archived and is no longer editable. Stay tuned for the next version, coming in the fall!


Project Members: 
/* Blinking LED
* ------------
* turns on and off a light emitting diode(LED) connected to a digital  
* pin, in intervals of 2 seconds. Ideally we use pin 13 on the Arduino 
* board because it has a resistor attached to it, needing only an LED
* Created 1 June 2005
* copyleft 2005 DojoDave <>
* based on an orginal by H. Barragan for the Wiring i/o board
int ledPin = 13;                 // LED connected to digital pin 13
void setup()
pinMode(ledPin, OUTPUT);      // sets the digital pin as output
void loop()
digitalWrite(ledPin, HIGH);   // sets the LED on
delay(1000);                  // waits for a second
digitalWrite(ledPin, LOW);    // sets the LED off
delay(1000);                  // waits for a second



hi alana,

missing some sections. please check my report example to see what should be included for the next lab. Also missing the photo.


Powered by Drupal - Design by Artinet