November 24, 2007
Reading for November 27th, are now posted. Enjoy!

October 2, 2007
To upload your thoughtless acts, create a new assignment page like any other lab. You'll see "Thoughtless Acts" listed as one of the assignment options.

May 24, 2008
This site has been archived and is no longer editable. Stay tuned for the next version, coming in the fall!

Blinking LED

Project Members: 
Andrew McDiarmid


The image uploaded, but I can't make it appear. I try to insert it, and the title gets inserted, but no image.


* Blink
* The basic Arduino example. Turns on an LED on for one second,
* then off for one second, and so on... We use pin 13 because,
* depending on your Arduino board, it has either a built-in LED
* or a built-in resistor so that you need only an LED.

int ledPin = 13; // LED connected to digital pin 13

void setup() // run once, when the sketch starts
pinMode(ledPin, OUTPUT); // sets the digital pin as output

void loop() // run over and over again
digitalWrite(ledPin, HIGH); // sets the LED on
delay(1000); // waits for a second
digitalWrite(ledPin, LOW); // sets the LED off
delay(1000); // waits for a second



Hey Andrew,

In addition to the missing photo, there's a couple sections missing from your report. Please check out my example report for guidance.

We just want to make sure you guys are all set for future lab reports as the labs get more challenging, so please make sure to grab on of the instructors so that we can go over the photo uploading process.

See ya! dave

Powered by Drupal - Design by Artinet