Lab 3: Sensor 1: Potentiometers

Description
I opted to do #2, which is to control the brightness of the LEDs with 3 potentiometers (one for each). During in-class lab, we learned how to solder wires to the potentiometers, which were then used for this assignment. I kept the code mostly the same, but I increased the sensitivity threshold.
 
Components

• 3x 220 Ohm Resistor
• 1x Red LED
• 1x Green LED
• 1x Blue LED
• 3x Potentiometers
• 1x Arduino Uno
• 1x Breadboard

• 1x Macbook Pro

 
Code

// Analog pin settings
int aIn = 0; // Potentiometers connected to analog pins 0, 1, and 2
int bIn = 1; // (Connect power to 5V and ground to analog ground)
int cIn = 2;

// Digital pin settings
int aOut = 9; // LEDs connected to digital pins 9, 10 and 11
int bOut = 10; // (Connect cathodes to digital ground)
int cOut = 11;

// Values
int aVal = 0; // Variables to store the input from the potentiometers
int bVal = 0;
int cVal = 0;

// Variables for comparing values between loops
int i = 0; // Loop counter
int wait = (1000); // Delay between most recent pot adjustment and output
int checkSum = 0; // Aggregate pot values
int prevCheckSum = 0;
int sens = 6; // Sensitivity threshold, to prevent small changes in
// pot values from triggering false reporting
// FLAGS
int PRINT = 1; // Set to 1 to output values
int DEBUG = 1; // Set to 1 to turn on debugging output

void setup()
{
pinMode(aOut, OUTPUT); // sets the digital pins as output
pinMode(bOut, OUTPUT);
pinMode(cOut, OUTPUT);
Serial.begin(9600); // Open serial communication for reporting
}

void loop()
{
i += 1; // Count loop
aVal = analogRead(aIn) / 4; // read input pins, convert to 0-255 scale
bVal = analogRead(bIn) / 4;
cVal = analogRead(cIn) / 4;
analogWrite(aOut, aVal); // Send new values to LEDs
analogWrite(bOut, bVal);
analogWrite(cOut, cVal);
if (i % wait == 0) // If enough time has passed...
{
checkSum = aVal+bVal+cVal; // ...add up the 3 values.
if ( abs(checkSum - prevCheckSum) > sens ) // If old and new values differ
// above sensitivity threshold
{
if (PRINT) // ...and if the PRINT flag is set...
{
Serial.print("A: "); // ...then print the values.
Serial.print(aVal);
Serial.print("\t");
Serial.print("B: ");
Serial.print(bVal);
Serial.print("\t");
Serial.print("C: ");
Serial.println(cVal);
PRINT = 0;
}
}
else
{
PRINT = 1; // Re-set the flag
}
prevCheckSum = checkSum; // Update the values
if (DEBUG) // If we want debugging output as well...
{
Serial.print(checkSum);
Serial.print("<=>");
Serial.print(prevCheckSum);
Serial.print("\tPrint: ");
Serial.println(PRINT);
}
}
}