Assignment: Introduction to Arduino and Physical Computing

Collaborators:

I modified the code from the example to make the led blink

kkonis 9/24/2009

I modified this code:

http://arduino.cc/en/Tutorial/Blink

to make the LED blink really fast, close to the threshold of on/off

/////////////

 /*

   Blink

  Turns on an LED on for one second, then off for one second, repeatedly.

  The circuit:

  * LED connected from digital pin 13 to ground.

  * Note: On most Arduino boards, there is already an LED on the board

  connected to pin 13, so you don't need any extra components for this example.

  Created 1 June 2005

  By David Cuartielles

MOD BY KK on 9/24/09

  http://arduino.cc/en/Tutorial/Blink

  based on an orginal by H. Barragan for the Wiring i/o board

  */

 int ledPin =  13;    // LED connected to digital pin 13

 // The setup() method runs once, when the sketch starts

 void setup()   {                

   // initialize the digital pin as an output:

   pinMode(ledPin, OUTPUT);     

 }

 // the loop() method runs over and over again,

 // as long as the Arduino has power

 void loop()                     

 {

   digitalWrite(ledPin, HIGH);   // set the LED on

   delay(25);                  // wait for a second

   digitalWrite(ledPin, LOW);    // set the LED off

   delay(25);                  // wait for a second

 }