Assignment: Introduction to Arduino and Physical Computing

Collaborators:

Assignment: Introduction to Arduino and Physical Computing
Collaborators: none

Description

Use the Arduino to control a light emitting diode and make it blink in different rate.

Components Used

• Light Emitting Diode (LED)
• Resistor

Arduino Code

int ledPin =  13;    // LED connected to digital pin 13

// The setup() method runs once, when the sketch starts

void setup()   {                
  // initialize the digital pin as an output:
  pinMode(ledPin, OUTPUT);     
}

// the loop() method runs over and over again,
// as long as the Arduino has power

void loop()                     
{
  digitalWrite(ledPin, HIGH);   // set the LED on
  delay(5000);                  // wait for a second
  digitalWrite(ledPin, LOW);    // set the LED off
  delay(1000);                  // wait for a second
}

Item