Blinking LED Breadboard

Description

Use the Arduino to control a light emitting diode and make it blink in different rate.

Components Used

  • Light Emitting Diode (LED)
  • Resistor

Arduino Code

/* Blinking LED
* ------------
*
* turns on and off a light emitting diode(LED) connected to a digital 
* pin, in intervals of 2 seconds. Ideally we use pin 13 on the Arduino 
* board because it has a resistor attached to it, needing only an LED


*
* Created 1 June 2005
* copyleft 2005 DojoDave <http://www.0j0.org>
* http://arduino.berlios.de
*
* based on an orginal by H. Barragan for the Wiring i/o board
*/


int ledPin = 13; // LED connected to digital pin 13


void setup()
{
pinMode(ledPin, OUTPUT); // sets the digital pin as output
}


void loop()
{
digitalWrite(ledPin, HIGH); // sets the LED on
delay(300); // waits for a second
digitalWrite(ledPin, LOW); // sets the LED off
delay(300); // waits for a second
}

Item

 

(Inserted by clicking on the picture icon in the page editor, resized by selecting the dimensions.)