S13. Output: DC motors
TUI Spring 2011 - DC Motor from Niranjan Krishnamurthi on Vimeo.
Start Date: Wednesday, March 2, 2011
Due Date: Tuesday, March 8, 2011 at 11:59PM
Lecture Slides
Available here
Before the Lab
You should have experiments with the piezo buzzer and various ways to control it. Congratulations!
In Lab Exercise
Objective
We will be learning how to control the DC motor with the various input devices you have learned about.
Background Information
The circuit we’re building in this lab will be significantly more complex than prior circuits. In addition to using the components you are already familiar with, you’ll also be using a DC Motor, diode (marked 1N4004 in the diagram), and a transistor (marked TIP120 in the diagram).
DC motors convert direct current into rotational motion. It’s our first actuating device.
Diodes allow current to flow only in one direction and not in the other. Motors often create current spikes as they turn on and off. These spikes can damage the transistor, so we use a diode in this circuit to protect the transistor from these spikes. Diodes have polarity, so the direction you install them matters. The bar in the schematic diagram corresponds to a white stripe on the actual diode. Current can only flow in the direction of the triangle.
Transistors have three terminals. The base controls the amount of current allowed to flow between the collector (positive terminal) and the emitter (negative terminal). Because the motor requires much more power than the Arduino is capable of providing, we use batteries to power the motor. The transistor allows us to control the amount of current that flows from the battery and through the motor.
Activities
1. Build the circuit shown below.
2. Load the program PotControlsMotor.txt onto the Arduino.
You should now be able to control the speed of the motor!
3. Use the other input transducers you’ve learned about to control the speed of the motor.
4. Try attaching different propellers and eccentric weights to your DC motor.
Homework
Explore motion as an output (in a form of display or tactile feedback). Use your DC motor to create vibration or rotational motion (e.g., pinwheels, dancing wires, etc.).
Optional: Combine it with other output (sound, lights, etc.)
Click here to post your assignment.
