Assignment 1: Blue Blinking

The goal of this project was to make and LED light blink through an Arduino connected to a laptop.
Components Used:

• Arduino Atmel Board (I own a Atmel so I have decided to use that instead of an Uno)
• 2 Wires of Different Colors
• 1 220 Ohm resistor
• 1 Bread Board
• 1 Blue LED

Initially the LED was set to be HIGH and LOW every 1 second, I changed that to 2 seconds HIGH and 1 second LOW, for a more pleasant blinking experience!
My Code:

/*

  Blink

  Turns on an LED on for one second, then off for one second, repeatedly.

  This example code is in the public domain.

 */

// Pin 13 has an LED connected on most Arduino boards.

// give it a name:

int led = 13;

// the setup routine runs once when you press reset:

void setup() {                

  // initialize the digital pin as an output.

  pinMode(led, OUTPUT);     

}

// the loop routine runs over and over again forever:

void loop() {

  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)

  delay(2000);               // wait for a second

  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW

  delay(1000);               // wait for a second

}