#1_09122013_LED_Blink_Pico

Approach
Connected the wire from pin13 >> breadboard >> 220 ohm resistor >> Blue LED >> GND.
Changed LED blinking to 2 seconds with 5 seconds interval.
Components Used
1. Arduino UNO
2. Solderless breadboard,Digikey #23273-ND
3. Blue LED,Jameco #183222
4. 220 ohm resistor, Jameco #107941
5. USB cable, Jameco #222607
Code
/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.

This example code is in the public domain.
*/

// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;
// the setup routine runs once when you press reset:
void setup() {
// initialize the digital pin as an output.
pinMode(led, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
delay(2000); // wait for 2 seconds
digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
delay(5000); // wait for 5 seconds
}