Lab 1 Submission - Morgan Wallace

This Arduino project was to make an LED blink.
The setup was a Arduino connected to my Macbook sending a signal through a 220 Ohm resistor to a red LED and then grounded. (see attached image)
Components Used:
1 220 Ohm Resistor
1 Arduino Uno
1 Red LED
1 Breadboard
 
The code was modified so that the light stayed on for 10 seconds and then blinked off for .99 seconds. This allowed me to easily get a good picture and proved that it would blink.
My Code:

int led = 13;

// the setup routine runs once when you press reset:

void setup() {                

  // initialize the digital pin as an output.

  pinMode(led, OUTPUT);     

}

// the loop routine runs over and over again forever:

void loop() {

  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)

  delay(10000);               // wait for a second

  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW

  delay(990);               // wait for a second

}