Introduction to Arduino and Physical Computing

Description
I use the Arduino Uno provided in our lab kits. A blue LED and 220Ω resistor are in series between the GND and Pin 13.

Components Used

• 1- Arduino Uno
• 1- 220 Ω Resistor
• 1 Blue LED

Code

/*

  Blink

  Turns on an LED on for one second, then off for one second, repeatedly.

  This example code is in the public domain.

 */

// Pin 13 has an LED connected on most Arduino boards.

// give it a name:

int led = 13;

// the setup routine runs once when you press reset:

void setup() {                

  // initialize the digital pin as an output.

  pinMode(led, OUTPUT);     

}

// the loop routine runs over and over again forever:

void loop() {

  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)

  delay(100);               // wait for a second

  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW

  delay(500);               // wait for a second

}