DESCRIPTION:
This lab assignment was to get the light to blink at different rates by setting up a circuit altering the Arduino code.
COMPONENTS USED:
1- Arduino Uno
1-220 ohm resistor
1-Breadboard
2- Cablues- Positive (Orange), Negative (Red)
CODE:
/*
Blink
Turns on an LED on for 1/10 second, then off for 1/10 second, repeatedly.
*/
// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;
// the setup routine runs once when you press reset:
void setup() {
// initialize the digital pin as an output.
pinMode(led, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
delay(100); // wait for 1/10 second
digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
delay(100); // wait for 1/10 second
}
- Login to post comments